High Quality Active / passive Buzzer Module for Arduino New DIY Kit Active buzzer low level modules

Total Variations : 2

Color : Active Buzzer Module,passive Buzzer

Desciption : 

Knowledge literacy:

Nowadays, many people are not very clear about the concept of active buzzer and passive buzzer. Here is a brief introduction.

I hope it will be helpful to everyone in the future.Note that the "source" here does not refer to the power source. It refers to the source of the shock.The features of passive buzzer are:

1 There is no oscillator inside the passive, so if a DC signal is used, it cannot be made to scream.

  Must use 2K~5K square wave to drive it

2 The frequency of the sound is controllable, and it can produce the effect of "multiple mifa Solaxi".

3 In some special cases, a control port can be reused with LEDThe characteristics of the active buzzer are:

1 The active buzzer has an internal oscillation source, so it will beep as long as it is powered on

2 The program control is convenient. The single-chip microcomputer can make a sound with a high and low level, but the passive buzzer can't.

 1. Module description 1. Module is driven by 9012 transistor 2. Working voltage is 3.3V-5V 3. With fixing bolt holes for easy installation 4. Small board PCB size: 2.8cm * 1.3cm  Two module interface description (3-wire system) 1 + external 3.3V-5V voltage (can be directly connected with 5v single-chip microcomputer and 3.3v single-chip microcomputer) 2-external GND3 out external single-chip IO port